A BIG THANKS TO THEROBOTEER WHO TOLD ME HOW TO DO THIS
ALL CREDIT GOES TO HIM
First of all you need a piece of PEX. If you have CPVC you can skip the next steps. This is just a scrap piece so don't cut it down to this size cut it down to roughly 13cm or 5 inches
Then get some scissors and keep turning them around until you get a nice fit for your dart
There are usually 2 rings of pipe you want to widen the inner diameter so that there is only one ring
IF YOU HAVE A COUPLER SKIP THIS AND THE NEXT STEP !
if not then use a knife or scissors to make the outer diameter smaller
Your pipe should fit with a tight seal but if not use a hammer and hit it down
Now make another one and tape/ hot glue them together
Thanks for reading :BBV:
No comments:
Post a Comment